Uit Hack42
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
ratchet.scad
module tooth(base, height, tipl, tiph, width) {
difference() {
intersection() {
translate([-(base+tipl)/2,0,0]) cube([base+tipl,height,width], center = false);
scale(v=[1,(height/(base+tipl))*2,0]) cylinder(r=(base+tipl)/2,h=width, $fs=0.01);
}
translate([-(base/2+tipl/2),0,0])
polyhedron( points = [ [0,0,0],[0,0,width],[0,tiph,0],[0,tiph,width],[tipl,0,0],[tipl,0,width] ],
triangles = [ [1,3,5],[0,4,2],[0,2,1],[2,3,1],[0,1,4],[4,1,5],[2,4,5],[2,5,3] ]);
}
}
//tooth2(7,7,5,5,1);
module ratchet(diam, nrteeth, height, tipl, tiph, width) {
//moves teeth down by this distance
down = 0.01 + (diam - diam * cos(180/nrteeth));
//make sure tooth's height is not lower than down movement
if (height <= down) {
ratchet2(diam, nrteeth, down, tipl, tiph, width, down);
} else {
ratchet2(diam, nrteeth, height, tipl, tiph, width, down);
}
}
module ratchet2(diam, nrteeth, height, tipl, tiph, width, down) {
// calculate tooth's base
base = 2 * sin(180/nrteeth) * diam;
union() {
cylinder(h=width,r=diam);
//teeth
for ( i = [0 : (nrteeth-1)] ) {
rotate( i * 360 / nrteeth, [0, 0, 1])
translate([-(0.25*base), (diam-2*down), 0]) // check the .25
tooth(base, height, tipl, tiph, width);
}
}
}
ratchet(10,6,3,5,7,1);
|
adjWheel.scad
module adjWheel(radius, width) {
circ = 2*radius*3.14159;
notch = (circ/40)*0.95;
edge = (circ-(notch*20))/400;
union() {
difference() {
cylinder(h=width,r=radius,$fs=0.01);
//notches
for ( i = [0:19] ) {
rotate( i * 360 / 20, [0,0,1])
translate([radius,0,0])
cylinder(h=width+0.01,r=notch,$fs=0.01);
}
}
//rounded edges
for ( i = [0:19] ) {
rotate( i * 360 / 20, [0,0,1])
translate([radius-2*edge,notch+edge,0])
cylinder(h=width,r=edge,$fs=0.01);
}
}
}
adjWheel(7,3);
|
