Gebruiker:BugBlue/OneWireSwitch

Project: OneWireSwitch
OneWireSwitch
Naam	OneWireSwitch
Door	BugBlue
Status	Afgerond
Madskillz	solderen, slijpen, zagen, schroeven, programmeren
Doel / Omschrijving
Onewire switch bouwen op basis van een oude switch
Alle Projecten - Project Toevoegen

noez

The idea

• Take a (broken) 19" switch
• Saw off the exces part of the switch you don't need (everything except the ports and the PCB directly underneath)
• figure out the pins
  • Pin 1: ground
  • pin 2: data
  • pin 3: VCC
• get a rasterized printboard and some headers
• make a shield for your arduino
  • Connect all the data pins to the data cables for the ports (16 in this case)
  • solder 16 resistors (1k or 4k7) from 5V VCC to all the datapins
  • solder 5V and GND
• screw the arduino to the board
• connect the shield to the arduino
• insert a USB cable
• upload the software
• close the case
• apply stickers
• place the switch in the rack
• If any time is left you can connect some leds

The software

please type in here...

Gezocht

Nyancat stickers. Ter hoogte van 1U :)