U hebt geen toestemming om deze pagina te bewerken, want:
De gevraagde handeling is voorbehouden aan gebruikers in de groep gebruikers.
Free text:
{{Project |Naam=OneWireSwitch |Eigenaar=BugBlue |Status=Afgerond |Skills=solderen, slijpen, zagen, schroeven, programmeren |Samenvatting=Onewire switch bouwen op basis van een oude switch }} == The idea == * Take a (broken) 19" switch * Saw off the exces part of the switch you don't need (everything except the ports and the PCB directly underneath) * figure out the pins ** Pin 1: ground ** pin 2: data ** pin 3: VCC * get a rasterized printboard and some headers * make a shield for your arduino ** Connect all the data pins to the data cables for the ports (16 in this case) ** solder 16 resistors (1k or 4k7) from 5V VCC to all the datapins ** solder 5V and GND * screw the arduino to the board * connect the shield to the arduino * insert a USB cable * upload the software * close the case * apply stickers * place the switch in the rack * If any time is left you can connect some leds == The software == <pre> please type in here... </pre> == Gezocht == Nyancat stickers. Ter hoogte van 1U :)
Pagina opslaan Bewerking ter controle bekijken Wijzigingen bekijken Annuleren